5062
Finisher or stacker sensor (paddle HP) removal
See
"Finisher/High-capacity output stacker assembly (continued)" on page 7-27
1.
Remove the option from the printer.
2.
Remove the paddle drive motor. See
page
4-267.
3.
Disconnect the cable from the sensor.
4.
Press the tabs to remove the sensor.
Finisher sensor (stapler access door interlock) removal
1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Disconnect the cable from the sensor.
4.
Pinch tab to remove the sensor.
4-274
Service Manual
"Finisher or stacker paddle drive motor assembly removal" on
"Finisher or stacker rear cover removal" on page
for the part number.
4-269.
Previous
Next
Go Back