Printhead removal, installation, and alignment
See
"Front, right, and top covers" on page 7-3
1.
Remove the system board upper shield. See
2.
Remove the printhead access cover. See
3.
Remove the AIO rear scanner cover. See
4.
Disconnect the three printhead cables (A) from the system board and feed them through the frame.
for the part number.
"System board upper shield removal" on page
"Printhead access cover removal" on page
"AIO rear scanner cover removal" on page
A
7562
4-28.
4-20.
4-190.
4-111
Repair information