146.Xx-Autocomp (Tray 1) Motor Error Service Check - Lexmark X792 Service Manual

146.xx—Autocomp (tray 1) motor error service check
Step Questions / actions
1 Turn the printer off, and open the system
board shield. Check the cable in connector
JTRAY1 (A) for proper connection to the
system board.
Is the cable properly connected?
2 Check the cable for damage.
Is the cable damaged?
3 Remove the standard media tray. Check the
cable (A) from the paper pick mechanism
assembly to the printer.
Is the cable properly connected?
4 Remove the paper pick mechanism assembly.
See "Paper pick mechanism assembly
removal" on page
Does the error reoccur?
A
4-116.
Yes
Go to step 2.
Replace the Tray 1
machine side cable. See
"Autocomp W2W cable"
on page 7-35.
Go to step 4.
Replace the system board.
See "System board
removal" on page 4-133.
7562
No
Reseat the cable.
Go to step 3.
Reseat the cable.
Problem solved.
2-81
Diagnostic information