Printer Setup; Defaults; Serial Number; Engine Setting X - Lexmark X792 Service Manual

Part no 7562

Hide thumbs Also See for X792:

Table of Contents

PRINTER SETUP

This setting is used by the printer to determine whether US or non-US factory defaults should be selected. The

following printer settings have different US and non-US values:

Printer default values

Paper Sizes setting in the General Settings menu

Default Paper Size (paper feeding sources which do not have

hardware size sensing capabilities)

Default Envelope Size

(envelope feeding sources which do not have hardware size

sensing capability)

Fax media size

PCL Symbol Set

PPDS Code Page

Universal Units of Measure

Warning: Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer's

factory settings.

This menu lets you view the total page counts of the printer or the page counts broken down into color and mono

pages printed. Unlike in previous printers, none of these values can be changed.

Touch Back to return to the Diagnostics menu.

You can view the serial number.

Warning: The engine setting should not be changed without specific instructions from the next level of support.

You can view the model name.

The two configuration IDs are used to communicate information about certain areas of the printer that cannot be

determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is

manufactured. However, you may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace

the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A through F.

Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs:

The default standard model Configuration ID is used instead.

Configuration ID is the only function available in DIAGNOSTICS.

Unless the menu is in DIAGNOSTICS, Check Config ID appears.

Non-US value

Diagnostic aids