7562
Finisher sensor (stapler access door interlock) removal
1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Disconnect the cable from the sensor.
4.
Pinch tab to remove the sensor.
Finisher or stacker sensor (pass thru) removal
See
"Finisher /High-capacity output stacker assembly" on page 7-37
1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Remove the finisher front cover. See
4.
Open the left access door, and pry out the left hinge (A) to lower the door.
5.
Push the door to the right to release the left hinge, and then release the right hinge.
4-352
Service Manual
"Finisher or stacker rear cover removal" on page
"Finisher or stacker rear cover removal" on page
"Finisher or stacker front cover removal" on page
4-346.
for the part number.
4-346.
4-337.
Previous
Next
Go Back