Lexmark X792 Service Manual page 59

Error code
245.01
245.05
245.08
Description
Tray 5 sensor is reached during POR
or after clearing the paper jam, tray 5
sensor is still triggered.
Possible causes:
• Obstruction on the sensor flag
• Obstruction on the paper path
• Paper got stuck between the
sensor
• Pick roll failure
• Paper pick failure
• System board failure
While feeding from tray 5, the paper
took a long time to clear the pass thru
sensor.
Possible causes:
• Incorrect paper size
• Incorrect paper guide setting
• Obstruction on the paper path
• Drive assembly failure
• Paper pick mechanism failure
• System board failure
• Obstructed pass thru sensor
• Pick rolls failure
While feeding from tray 5, the paper
did not reached the pass thru sensor.
Possible causes:
• Contaminated or worn-out pick tire
• Damaged pick assembly
• Incorrect media loading
• Obstruction on the paper path
• Damage tray restraints
Action
1. Clear anything in the paper path that might
cause the paper to jam.
2. Check if the sensor flag is free from any
obstruction.
3. Properly install the media on the tray.
If problem persists, go to "242.01, 243.01, 244.01,
245.01 —Paper Jam (550-sheet/2000-sheet input
option) service check" on page
1. Clear the paper path.
2. Make sure the paper setting match the media.
3. Check if the pick roll are worn out.
If problem persists, go to "241.03, 242.03, 243.03,
244.03, 242.05, 243.05, 244.05, 245.05—Paper
jam (550-sheet/2000-sheet input option) service
check" on page 2-104
1. Check if media is loaded properly
2. Check tray restraints
3. Clear the paper path
4. Reseat the option tray 5.
5. Check the pick arm roll in tray 5 and replace if
worn.
If problem persists, go to "280.06—Media missing
jam service check" on page
Diagnostic information
7562
2-103.
2-111.
2-19