7562
Finisher or stacker sensor (bin-full receive) removal
See
"Finisher assembly" on page 7-32
1.
Remove the option from the printer.
2.
Remove the option rear cover. See
3.
Remove the two screws (A) securing the sensor.
4.
Disconnect the cable, and remove the sensor.
Finisher or stacker sensor (bin-full send) removal
See"Finisher assembly" on page 7-32
1.
Remove the option from the printer.
2.
Remove the finisher or stacker controller card assembly. See
assembly removal" on page
4-324
Service Manual
for the part number.
"Finisher or stacker rear cover removal" on page
for the part number.
4-310.
"Finisher or stacker controller card
4-322.