Sensor (Adf Sheet Through) Removal - Lexmark X792 Service Manual

5.
Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
6.
Remove screw (B) from the ground strap.
7.
Remove the sensor (ADF media exit) fan bracket assembly.
Installation notes:
•
Remove the fan filter cover assembly from the used sensor fan bracket assembly, and install on the new
assembly.
•
Be sure to reinstall the ground strap.

Sensor (ADF sheet through) removal

See "ADF electronics" on page 7-24
1.
Remove the ADF turn guide. See
2.
Remove the screw (A) holding the sensor bracket.
3.
Disconnect the sensor cable.
for the part number.
"ADF turn guide removal" on page 4-181.
Repair information
7562
4-187