Finisher or stacker sensor (tamper HP left and right) removal
See"Finisher assembly (continued)" on page 7-34
1.
Remove the option from the printer.
2.
Remove the option top cover. See
3.
Disconnect the cable from the sensor.
4.
Pinch the tabs (A) to remove the sensors.
Finisher or stacker standard output bin LED and LED lens removal
See"Finisher assembly" on page 7-32
1.
Remove the option from the printer.
2.
Remove two screws (A), and pull out the sensor cover.
3.
To remove the LED, remove the screw (B), and then disconnect the cable from the LED card.
for the part number.
"Finisher or stacker top cover removal" on page
for the part number.
7562
4-333.
4-329
Repair information