Usb Hs Test Mode; Beacons Test; Duplex Tests; Duplex Quick Test - Lexmark X792 Service Manual

CTS PIO Error
CTS Interrupt Error
Once the maximum count is reached or a failure occurs, the test stops.
X
Press Stop ( ) to cancel the test.

USB HS Test Mode

1. From the Diagnostics menu, navigate to:
HARDWARE TESTS > USB HS Test Mode
2. Select the desired Port.
3. Select the desired Test.
Ports
Port 0
Port 1
Port 2
Port 3
To cancel the test, turn the printer off.

Beacons Test

Select On to turn on all printer beacons. The beacons remain on until you select Off.

DUPLEX TESTS

Duplex Quick Test

This test verifies if the Duplex Option Top Margin is set correctly. This test prints a duplexed version of the Quick
Test Page that can be used to adjust the Top Margin for the back of the duplexed page. You can run one
duplexed page (Single) or continue printing duplexed pages (Continuous) until Stop (
You must use either Letter or A4 paper.
1.
From the Diagnostics menu, navigate to:
DUPLEX TESTS > Duplex Quick Test
2.
Select Single or Continuous.
•
The single test cannot be canceled.
•
The printer attempts to print the Quick Test Page from the default paper source. If the default paper
source supports only envelopes, then the page is printed from Tray 1.
•
Check the Quick Test Page for the correct offset between the placement of the first scan line on the
front and back side of a duplexed sheet.
•
If adjustment is necessary, the Top Margin in the Registration menu must be adjusted first. The
Duplex Top Margin Offset may be adjusted next.
•
A positive offset moves the text down the page and widens the top margin, while a negative offset
moves the text up the page and narrows the top margin.
3.
Press Stop (
Tests
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enable
X
) to cancel the test.
7562
X
) is pressed.
3-17
Diagnostic aids