Printhead Cable And Cradle Removal - Lexmark 5000 Service Manual

4093/4094

Printhead Cable and Cradle Removal

1. Remove the accent, right and center covers.
2. Remove the printhead carrier assembly.
3. Disconnect the printhead cable from the encoder card. Note the
routing of the cable under the retaining clip on the carrier.
4. Separate the cradle from the printhead carrier assembly by
pushing out the cradle latches [A].
5. Feed the folded end of the printhead cable through the opening
in the carrier assembly and remove the cable.
Note: Use the illustration to assemble the carrier parts in the correct
sequence.
4-12
Service Manual