Retrofitting The Lashing Points; Replacing The Back Plates - Otto Bock Discovery tmax Service Manual

Service Work

3.5.3 Retrofitting the Lashing Points

WARNING
Prohibited installation of parts after an accident
Serious injuries due to unidentifiable product defects
► Continuing to use the product after a traffic accident is prohibited.
1) Screw the front lashing points onto the seat frame using the 2 supplied Allen head screws, but do not tighten
the screws (see Fig. 9, item 1).
INFORMATION: The front lashing points must face to the outside.
2) Screw on the rear lashing points using the back plate mounting screws (see Fig. 10, item 1). Also mount a pin
between the rear mounting screws, respectively (see Fig. 10, item 2; see Fig. 11, item 3).
INFORMATION: The rear lashing points must face to the inside.
3) Tighten all Allen head screws/mounting screws to a torque of 10 Nm.
4) Attach the "Anchor Point/Fixing Point" sticker to the lashing points so it is readily visible from the outside (no
illustration).

3.5.4 Replacing the Back Plates

INFORMATION
To adjust the back angle, see the Instructions for Use (Qualified Personnel), reference number 647G734.
1) Loosen 2 x Allen head screws on the back plate/seat frame connection (see Fig. 11, item 1). The rear cross
tube on the seat frame does not have to be removed (see Fig. 12, item 1).
2) If a lashing point is installed, also loosen 1 x Allen head screw and 1 x pin (see Fig. 11, item 2).
3) Loosen 3 x Allen head screws on the back plate/push handle connection (see Fig. 11, item 3, 1 x Allen head
screw not illustrated).
4) Remove and replace the back plate.
INFORMATION:If required, the back plate depth position can be adjusted after loosening the 2nd back
plate (see Fig. 12, item 2).
5) Reinstall the back plate. Screw the rear cross tube into place at the same time (see Fig. 12, item 1).
6) Tighten all Allen head screws to 10 Nm.
12 | Ottobock
9 10
discovery tmax