Removing The Electric Controls On; The Right Side Of The Handlebar - APRILIA pegaso 650 i.e. Service Manual

CHASSIS

7.1.19 REMOVING THE ELECTRIC CONTROLS ON

THE RIGHT SIDE OF THE HANDLEBAR

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
N
Turn the ignition switch to position "1".
PARTIAL REMOVAL
NOTE
The screw (1) is longer than the screw (2). Upon
reassembly, take care to position them correctly.
N
Unscrew and remove the two screws (1) (2) fastening
the two halves of the casing (3) (4) at the bottom.
Electric controls screw driving torque: 2 Nm (0.2
kgm).
N
Split the two halves of the casing (3) (4) apart and re-
move them.
a
CAUTION
When reassembling, first set the lower half of the
casing (4) in place, making sure the special locating
dowel enters the relevant hole on the handlebar.
COMPLETE REMOVAL
N
Carry out the partial removal, see above.
N
Free the cabling from the two clamps (5) (6).
NOTE
Prepare the same number of clamps, which will
be required for reassembly.
N
Remove the dashboard fairing, see 7.1.27 (REMOV-
ING THE DASHBOARD FAIRING).
N
Release the wiring from the fastening clamp (7).
N
Disconnect the right dip switch electric connector (8).
a
CAUTION
When reassembling, make sure the connector (8) is
plugged in properly.
N
Remove the two halves of the casing (3) (4).
7 - 18
- 00
Pegaso 650 I.E.
Release 00/2002-02