CHASSIS
7.1.17 REMOVING THE THROTTLE GRIP
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the right antivibration weight unit, see 7.1.11
(REMOVING THE ANTIVIBRATION WEIGHT).
N
Remove the right handgrip, see 7.1.14 (REMOVING
THE HANDGRIP).
NOTE
The screw (1) is longer than the screw (2). Upon
reassembly, take care to position them correctly.
N
Unscrew and remove the two screws (1) (2) fastening
the two halves of the casing (3) (4) at the bottom.
Electric controls screw driving torque: 2 Nm (0.2
kgm).
N
Split the two halves of the casing (3) (4) apart.
a
CAUTION
When reassembling, first set the lower half of the
casing (3) in place, making sure the special locating
dowel enters the relevant hole on the handlebar.
N
Disconnect the throttle cable (5).
N
Pull the throttle grip (6).
7.1.18 REMOVING THE FRONT BRAKE LEVER
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
COMPLETE REMOVAL
N
Drain the front braking system, see 7.5.6 (DRAINING
THE BRAKING SYSTEMS).
N
Unscrew and remove the front brake lever connection
screw (7) and take the two sealing washers (8).
Front brake lever connection screw (7) driving
torque: 20 Nm (2.0 kgm).
a
CAUTION
Upon reassembly, replace the two sealing washers
with two new washers of the same type.
N
Put a nylon bag on the connection (9) and seal it with
adhesive tape.
7
- 16
- 00
ã
Follow
Pegaso 650 I.E.
Release 00/2002-02