APRILIA pegaso 650 i.e. Service Manual page 101

Pegaso 650 I.E.
ã
Follow
N
Remove the exhaust pipe unit (12) by withdrawing it
from its front part.
NOTE
Move the exhaust pipe unit (12) gradually, trying
to find the best combination of movements and withdraw
it correctly (raise the front part, lower the rear part and
move the whole so that it carries out a forward screwing
movement; the rear lower part must pass through the
turns of the rear shock absorber spring) (see figure).
a
CAUTION
Check and, where necessary, replace the gaskets
(17) (18) with two new ones of the same type.
Plug the engines exhaust pipe openings so as to pre-
vent any foreign bodies entering.
3.2.2 REMOVING THE GEAR LEVER
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
a
CAUTION
Before removing the lever, mark lever and shaft (see
figure), in order to be able to position it correctly
upon reassembly.
N
Position the vehicle on the stand.
N
Loosen and remove the screw (19).
Shifting lever screw driving torque: 10 Nm (1.0
kgm).
N
Slide the gearshift lever (20).
3.2.3 REMOVING THE DRIVE PINION PROTECTION
CASING
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
a
WARNING
Let the engine cool down until it reaches room tem-
perature.
N
Position the vehicle on the stand.
N
Unscrew the screw (21), keeping the rear brake pedal
pressed downwards.
N
Unscrew and remove the two screws (22) (23).
Pinion casing screw driving torque: 5 Nm (0.5
kgm).
N
Remove the casing (24), raising it slightly and turning it
towards the outside.
Release 00/2002-02
ENGINE
3 - 7
- 00