Assembling The Rear Wheel Bearings - APRILIA pegaso 650 i.e. Service Manual

Pegaso 650 I.E.

7.3.14 ASSEMBLING THE REAR WHEEL BEARINGS

If provided:
N
Remove the rear wheel bearings, see 7.3.13 (DISAS-
SEMBLING THE REAR WHEEL BEARINGS).
Work from the left-hand side of the wheel:
NOTE
Have the appropriate special tool m to hand:
– aprilia part# 8140180 (Kit for bearings in the range
Ø10 mm to Ø 30 mm).
N
Using the appropriate pad, insert the left bearing (1)
completely.
NOTE
The right bearing must be inserted until its con-
tact with the wheel hub shoulder is complete.
N
Insert the elastic ring (2).
NOTE
The elastic ring (2) is provided only on the left
side of the wheel.
Work from the right-hand side of the wheel:
N
Insert the spacer (3).
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8140180 (Kit for bearings in the range
Ø10 mm to Ø 30 mm).
N
Use a special pad to insert the right bearing (4).
NOTE
The complete insertion of the right bearing (4)
will bring the following components into contact:
– left bearing (1);
– spacer (3);
– right bearing (4).
a
CAUTION
After the contact with the left bearing (1), do not push
further, in order to avoid forcing the elastic ring (2).
NOTE
Once the right bearing (4) has been inserted,
check the coaxiality of the following components:
– left bearing (1);
– spacer (3);
– right bearing (4).
Work from the left-hand side:
N
Install a new seal (5).
N
Insert the spacer ring (6) with its longer diameter to-
wards the outside of the vehicle.
Release 00/2002-02
CHASSIS
7 - 51
- 00