Removing The Left Handlebar Handgrip; Removing The Left Handlebar Electrical Controls - APRILIA RS 50 Workshop Manual

Body work
RS 50
REMOVING
THE LEFT HANDLEBAR HANDGRIP
1
Read carefully (PRECAUTIONS AND GENERAL
2
INFORMATION).
Position the motorcycle on the stand.
Switch the ignition key to the " " position.
Hold the counterweight (1) while loosening and
removing the screw (2).
Remove the counterweight (1).
Insert the point of a compressed air gun between the
handgrip (3) and the handlebar (4).
Blow in air while moving the point of the gun in a
clockwise direction, gripping and removing the
handgrip (3) with the other hand at the same time.
3
4
REMOVING THE LEFT HANDLEBAR
7
ELECTRICAL CONTROLS
Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Position the motorcycle on the stand.
Switch the ignition key to the " " position.
Unscrew the two screws (5) that secure the two half
shells underneath.
Divide the two half shells.
Free the wiring from the clamps that fix it to the frame.
5
5
NOTE
Prepare the same number of new clamps for
refitting.
6
Disconnect the left high/low beam selector connector.
WARNING
When refitting, make sure the connector is
plugged in properly.
Remove the two half shells (6-7).
7
7-9
ch. 7
Release 00 2001-03