Removing The Handlebar; Removing The Rear-View Mirrors - APRILIA pegaso 650 i.e. Service Manual

CHASSIS

7.1.22 REMOVING THE HANDLEBAR

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the grips, see 7.1.14 (REMOVING THE
HANDGRIP).
N
Partially remove the electric controls, see 7.1.19 (RE-
MOVING THE ELECTRIC CONTROLS ON THE
RIGHT SIDE OF THE HANDLEBAR) and 7.1.16 (RE-
MOVING THE ELECTRIC CONTROLS ON THE LEFT
SIDE OF THE HANDLEBAR).
N
Remove the throttle grip, see 7.1.17 (REMOVING THE
THROTTLE GRIP).
~ Release the cables from the fastening clamps (1).
a
CAUTION
Prepare the same number of clamps, which will be re-
quired for reassembly.
~ Remove the rubber protection element (2).
NOTE
Before removing the U bolt (3), mark its position
on the handlebar so it can be refitted in the right place.
~ Unscrew and remove the two screws (4).
Handlebar U bolt screw driving torque: 25 Nm (2.5
kgm).
~ Remove the U bolt (3).
N
Remove the handlebar (5).

7.1.23 REMOVING THE REAR-VIEW MIRRORS

N
Position the vehicle on the stand.
N
Raise the protection element (6).
N
Loosen and remove the stop nut (7).
a
CAUTION
Upon reassembly, before tightening the lock nut (7),
make sure that the rear-view mirror support rod is di-
rected in such a way as to be aligned with the handle-
bar.
N
Withdraw the entire rear-view mirror unit (8) upwards
and remove it.
N
Repeat these operations to remove the other rear-view
mirror.
7 - 20
- 00
Pegaso 650 I.E.
Release 00/2002-02