APRILIA pegaso 650 i.e. Service Manual page 36

GENERAL INFORMATION
ã
Follow
NOTE
Where the transfer features application tape
✱
(5) , the tape must be removed 20-30 minutes after the
application of the transfer.
✱
The application tape is used to facilitate the application
of trademarks and letters, arranging them in the correct
place on the surface to be decorated, and to give the
self-adhesive more body during application.
N
Remove the application tape (5) from the surface of the
transfer.
N
In order to assure good adhesion, move the spatula
over the transfer again, concentrating in particular on
the edges and corners.
NOTE
With the wet method, the final level of the trans-
fer is reached approx. 48 hours after application.
N
Once the application tape has been removed, make
sure there are no air bubbles anywhere on the surface.
In the event air bubbles are encountered:
N
Use a pin or paper cutter (6) to make a hole in the edge
(7) of the air bubble.
N
Using the spatula (1), work from the edge opposite the
hole and push the bubble so the air escapes.
1 - 26
- 00
Pegaso 650 I.E.
Release 00/2002-02