Rear Wheel Pin; Rear Wheel Rim; Rear Tyre; Rear Brake Disc - APRILIA pegaso 650 i.e. Service Manual

Pegaso 650 I.E.
7.3.5 REAR WHEEL GASKETS
N
Check the conditions of the gasket (1); if it is damaged
or excessively worn, change it.
a
WARNING
Always change both seals.
Always replace the gaskets with gaskets of the same
type.

7.3.6 REAR WHEEL PIN

N
Check the eccentricity of the pin wheel (2) by means of
a comparator. If the eccentricity exceeds the limit val-
ue, change the pin wheel (2).
Maximum eccentricity: 0.25 mm.

7.3.7 REAR WHEEL RIM

N
Using a comparator, make sure that the radial (A) and
axial (B) eccentricity of the rim (3) do not exceed the
limit value.
Excessive eccentricity is usually caused by worn or
damaged bearings.
If, after changing the bearings, the value does not fall
within the indicated limit, change the rim (3).
Maximum radial and axial eccentricity: 2 mm.

7.3.8 REAR TYRE

N
Check the state of the tyre, see 2.30 (TYRES) and 7.4
(TYRES).

7.3.9 REAR BRAKE DISC

N
Check the rear brake disc, see 7.6.2 (CHECKING THE
REAR BRAKE DISC).
Release 00/2002-02
CHASSIS
7 - 47
- 00