Positioning The Vehicle On The Rear Support Stand M; Positioning The Vehicle On The Front Support Stand M - APRILIA pegaso 650 i.e. Service Manual

Pegaso 650 I.E.
 0/3)4)/.).' 4(% 6%()#,% /. 4(%
3500/24 34!.$
1.8.1 POSITIONING THE VEHICLE ON THE REAR
SUPPORT STAND m
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8705021 (rear support stand);
– aprilia part# 8140204 (support pins).
N
Loosen the knob (1).
N
Withdraw the fork support (2) and extract it from the
stand seat.
N
Insert the support pin (3).
N
Repeat the previous operations on the opposite side of
the stand.
N
Remove the two drive chain guards, see 7.1.29 (RE-
MOVING THE DRIVE CHAIN GUARDS).
N
Pull the front brake lever (4) thoroughly, and position a
plastic clamp (6), interposing a small piece of card-
board (5), in such a way as to keep the front brake lever
pulled.
a
WARNING
Raise the vehicle by means of the two rear fork arms
only.
N
Insert the stand from the rear side of the vehicle and
position it so that the two support pins (3) rest on the
lower part of the rear fork rods:
– the right support (Pos.A);
– the left support (Pos.B).
N
Withdraw the support pins (3) and make them hit
against the rear fork.
N
Tighten the two knobs (1).
N
Push the stand forward (7) until the support pin (3)
rests, on the right side, against the rear fastening plate
of the lower chain guard.
NOTE
Have someone help you keep the vehicle in ver-
tical position with the two wheels on the ground.
a
WARNING
Grasping the stand in another way than indicated in
the figure may cause your fingers to be crushed be-
tween the stand and the ground.
N
Grasp the terminal central part of the stand (7) (Pos.C).
N
Push the stand (7) downwards until it reaches the end
of its stroke (see figure).
1.8.2 POSITIONING THE VEHICLE ON THE FRONT
SUPPORT STAND m
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8146486 (front support stand);
– aprilia part# 8140590 (washers for front support
stand).
N
Position the vehicle on the appropriate rear support
stand, see 1.8.1 (POSITIONING THE VEHICLE ON
THE REAR SUPPORT STAND m).
N
Position the two special washers (8) on the upper ends
(9) of the stand.
N
Insert the two ends of the stand (9) in the two holes (10)
positioned on the lower ends of the front fork.
a
WARNING
Grasping the stand in another way than indicated in
the figure may cause your fingers to be crushed be-
tween the stand and the ground.
N
Grasp the terminal central part of the stand (11)
(Pos.C).
Release 00/2002-02
N
Push the stand (11) downwards until it reaches the end
of its stroke.
GENERAL INFORMATION
1 - 17
- 00