APRILIA pegaso 650 i.e. Service Manual page 279

Pegaso 650 I.E.
7.9.7 REASSEMBLING THE REAR FORK
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 2.23.1 (ADJUSTING THE REAR
FORK).
N
Smear a film of grease over the entire length of the fork
pin, see 1.6 (LUBRICANT CHART).
a
CAUTION
In the first phase the pin (1), the adjusting bush (2)
and the locking metal ring (3) must be screwed man-
ually.
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8101945 (rear fork pin metal ring span-
ner).
N
Introduce and screw the pin (1) that fastens frame/en-
gine/rear fork with the appropriate socket spanner, at
the same time holding the adjusting bush (2) in its posi-
tion, see 1.7 (SPECIAL TOOLS m).
N
Tighten the adjusting bush (2) until it comes into con-
tact with the rear fork, then give it another 1/4 turn.
Adjusting bush tightening: contact + 1/4 turn.
N
Tighten the rear fork pin (1), at the same time holding
the adjusting bush (2) in its position.
Fork pin driving torque: 100 Nm (10 kgm).
N
Refit the washer.
N
Hold the adjusting bush (2) in its position and screw the
locking metal ring (3) at the same time.
Fork pin metal ring driving torque: 35 Nm (3.5 kgm).
a
CAUTION
From this point on, reassemble the fork following the
removal procedure in the reverse order, starting from
NOTE (A), see 7.9.1 (REMOVING THE REAR FORK).
Release 00/2002-02
CHASSIS
7 - 87
- 00