APRILIA pegaso 650 i.e. Service Manual page 270

CHASSIS
ã
Follow
N
Remove the stop ring (8) by means of a cut-tipped
screwdriver.
a
CAUTION
Wash all the components with a clean detergent.
N
Position the slider-tube assembly in the vice as indicat-
ed in the figure (B).
a
CAUTION
It may be difficult to unscrew the screw (9) complete-
ly; in this case, prevent the tube from rotating.
N
Unscrew and remove the screw (9), taking the washer.
Right slider centre screw driving torque: 50 Nm (5.0
kgm).
N
Remove the tube (10) and withdraw the following com-
ponents:
– bottom pad (11);
– pumping element (12) complete with spring (13).
N
Position the slider in a vice with the opening facing up-
wards.
a
CAUTION
To extract the sealing ring (14), heat the outer part of
the slider with a jet of hot air.
N
Withdraw and remove the following components:
– sealing ring (14);
– cap (15).
7 - 78
- 00
Pegaso 650 I.E.
Release 00/2002-02