Setting The Drying Time After Printing (When Only Printing) - Roland TrueVIS VG2-640 User Manual

Adjusting the Ink-drying Method

Setting the Drying Time after Printing (When Only Printing)

To dry the ink thoroughly, set the drying time after the 1st page is printed. This setting applies to output data de-
signed only for printing.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEATER MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
HEATER MENU
DRYING TIME
4.
Press [▶] to display the screen shown below.
DRYING TIME
PRINT
5.
Press [▶] to display the screen shown below.
PRINT
0min
6.
Press [▲] or [▼] to select the drying time.
7.
Press [ENTER] to confirm your entry.
8.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: 0 min
• The next operation is not started until the set time elapses.
• During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to finish the drying time and start the next operation.
• Hold down [PAUSE] while [PAUSE] is lit to cancel the output.
• When the drying time has been set in the software RIP, priority is given to the software RIP's setting.
• This setting is ignored for output data designed for printing and cutting. To set the drying time after printing when printing
and cutting, see the following section.
RELATED LINKS
・ P. 159 "Setting the Drying Time after Printing (When Printing and Cutting)"
158
1. Optimizing the Output Quality
0min