Setting The Drying Time After Printing - Roland TrueVIS VF2-640 User Manual

Setting the Drying Time after Printing

To dry the ink thoroughly, set the drying time after the 1st page is printed.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEATER MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
HEATER MENU
DRYING TIME
4.
Press [▶] to display the screen shown below.
DRYING TIME
0min
5.
Press [▲] or [▼] to select the drying time.
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: 0 min
• The next operation is not started until the set time elapses.
• During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to finish the drying time and start the next operation.
• Hold down [PAUSE] while [PAUSE] is lit to cancel the output.
• When the drying time has been set in the software RIP, priority is given to the software RIP's setting.
0min
Adjusting the Ink-drying Method
1. Optimizing the Output Quality
89