Rear Wheels - wsm m9540 Workshop Manual

M9540Low Profile, WSM

(2) Rear Wheels

Tread (a)
1515 mm
480/70R28
59.65 in.
(1) Rear Wheel Mounting Nut
(2) Rear Disc Mounting Nut
Rear tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and / or disc mounting bolts.
2. Change the position of the rim and disc (right and left) to the
desired position, and tighten the bolts.
IMPORTANT
• Always attach wheels as shown in the figure.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and thereafter according to service interval.
(Refer to "[5] CHECK POINTS OF EVERY 50 HOURS" at
"7. CHECK AND MAINTENANCE".)
Tightening
torque
A B
1585 mm
62.40 in.
(3) Rear Wheel Disc
Rear wheel mounting
nut
Rear disc mounting nut
C
1723 mm 1777 mm
67.83 in. 69.96 in.
(4) Rear Wheel Rim
LG-3
G GENERAL
343 to 401 N·m
M18 35.0 to 41.0 kgf·m
254 to 297 lbf·ft
259.9 to 304.0 N·m
M16 26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
W1082792
D E
1915 mm
75.39 in.
(a) Tread
KiSC issued 09, 2008 A