Rear Wheels - wsm B2420 Workshop Manual

B2420, WSM

(2) Rear Wheels

IMPORTANT
• Always attach tires as shown in the figures.
• If not attached as illustrated, transmission parts may be damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving
the tractor 200 m (200 yards) and there after daily check service.
8-16 Farm
734 to 964 mm
(28.9 to 37.9 in.)
A: Tread
equipped tires.
1. Loosen the nut (1) of cotter pin bolt (3).
2. Remove the snap pin (5) and wheel hub pin (4).
3. Change the tread to desired position.
4. Re-set the wheel hub pin (4) , snap pin (5) and cotter pin bolt (3).
(1) Nut
(2) Spring Washer
(3) Bolt
9.5-16 Farm
790 to 1068 mm 806 to 1088 mm
(31.1 to 42.04 in.) (31.8 to 42.83 in.)
• Insert the bolt (2) from the recessed side of both cotters
(1) Cotter
(2) Bolt
Rear tread can be adjusted as shown with the standard
To change the tread width
9.5-18 Farm
NOTE
and tighten the nut (4) with flat side of cotter as shown in
figure.
G-48
GENERAL
9Y1210436GEG0023US0
(4) Wheel Hub Pin
(5) Snap Pin
9Y1210436GEG0022US0
(3) Spring Lock Washer
(4) Nut
9Y1210436GEG0065US0
KiSC issued 06, 2012 A