Nortel CallPilot 201i Hardware Installation page 160

Connecting peripheral devices to the 201i server
Result: The operating system boot sequence begins, and
communication with the switch occurs. The HEX display shows NT (for
about 30 seconds), followed by OK.
Note: The system reboots more than once. The HEX display repeats
with each reboot.
Note: Before OK appears, one of the following messages can appear,
but not for more than one second: CDLN, C:01, or C:02. This is normal
operation.
If OK does not appear, refer to the CallPilot server maintenance and
diagnostics guide for your serve
160
r
for troubleshooting instructions.
Standard 1.07
CallPilot