Setting Scsi Device Termination - Nortel CallPilot 201i Hardware Installation

Preparing peripheral devices

Setting SCSI device termination

Introduction
If you want to connect SCSI devices in a daisy chain, the last device in the
daisy chain must be terminated. This section describes how to terminate the
SCSI devices.
ATTENTION
Supported daisy chain connection scenarios
The first device in a SCSI device daisy chain can be either the tape drive or
the CD-ROM drive. However, because the Tandberg SLR5 tape drive is
already internally terminated at the factory, Nortel recommends that you
connect the tape drive as the last device.
The following diagrams show the supported daisy chain and SCSI cable
connections for your switch. The CD-ROM drive is the first device in the
daisy chain. The tape drive is the last device.
130
Ensure that the CD-ROM and tape drives are powered
down before changing the device termination.
Standard 1.07
CallPilot