Peripheral Connectivity - Nortel CallPilot 201i Hardware Installation

November 2006

Peripheral connectivity

Introduction
Peripheral equipment is attached to the 201i server on the server faceplate.
Faceplate connections
ATTENTION
The following peripheral devices connect to the 201i server faceplate:
monitor (SVGA)
keyboard
mouse
MPC card (permanent connection)
SCSI cable (permanent connection)
Monitor, keyboard, and mouse
You must connect a monitor, keyboard, and mouse to run the Configuration
Wizard or to install the operating system on the 201i server as part of a
recovery process.
All three peripheral components are hot-pluggable.
201i Server Hardware Installation
Connections made to the faceplate (with the exceptions
noted below) are temporary only, because you must
remove the cabinet cover to make these connections.
The system does not meet specifications for radiated
EMI if you remove the cabinet cover.
About the 201i server
31