Nortel CallPilot 201i Hardware Installation page 60

Installing the 201i server in a large Meridian 1 system
ATTENTION
Remove the tie wraps where applicable to free the cable.
c. Remove the connector, I/O filter assembly, and all mounting
hardware from the inside of the I/O panel so the slot is completely
vacated.
Retain the mounting hardware (that is, screws, tie wrap base,
standoffs, and so on). You will reuse this hardware to fasten the
NTRH3501 cable.
4 Repeat step 3 to remove the existing backplane cable for the right slot.
Store the cable, I/O filter assembly, and mounting hardware for this cable
with your Meridian 1 spares. You will not use them with the 201i server.
60
If you attempt to pull the connector off without
pressing the lock tab, you can pull the connector
shroud off the backplane. If this happens, refer to
the adjacent connectors for correct key positioning,
and then replace the connector shroud.
Standard 1.07
CallPilot