Setting The Cd-Rom Drive Scsi Id And Dip Switches - Nortel CallPilot 201i Hardware Installation

Preparing peripheral devices
Setting the CD-ROM drive SCSI ID and DIP
switches
Introduction
This section describes how to set the CD-ROM drive SCSI ID and DIP
switches.
ATTENTION
Note: The CD-ROM drive discussed in this section is the external SCSI
CD-ROM drive (NTRH9105).
To set the CD-ROM drive SCSI ID
The SCSI ID setting is located on the back of the CD-ROM drive. (See the
diagram that follows.)
To change the SCSI ID, use the blade of a screwdriver to rotate the SCSI ID
dial arrow to 3.
126
You must power down the CD-ROM drive before
changing the SCSI ID and DIP switches.
SCSI-Out
SCSI-In
SCSI interface
connectors - in and out
DIP SCSI ID
switches
1 2 3 4 5
PARITY EJECT
SCSI ID
TERM BLOCK
TEST
R L
AC power input
Standard 1.07
Power
switch
G101176
CallPilot