Installing The 201I Server - Nortel CallPilot 201i Hardware Installation

November 2006

Installing the 201i server

Introduction
This section describes how to install the 201i server inside the Media
Gateway or Media Gateway Expansion.
Before you begin
Determine which pair of consecutive slots are to contain the 201i server. The
following table identifies the Media Gateway and Media Gateway
Expansion slots into which the CallPilot 201i server can be installed:
Unit
Media Gateway
Media Gateway
Expansion
Note: The 201i server will not function properly when installed in slots 3
and 4.
For more information about card slots, refer to the Succession 1000
Planning and Installation Guide (NTP 553-3023-210).
For the logical slot numbers that you must use when you configure the
Succession 1000 system, see "Card slots" on page 97.
201i Server Hardware Installation
Installing the 201i server in the Succession 1000 system
The 201i server
can be installed in
Slots 1 and 2
Slots 2 and 3
Slots 7 and 8
Slots 8 and 9
Slots 9 and 10
Ineligible slots
Slot 0 is dedicated to the SSC card.
Slot 4 (includes slots 5 and 6) is
not used.
Slot 10 is a double-wide slot. The
second half of this slot does not
have a backplane connector.
107