To Complete The Installation And Start The 201I Server; Completing The Installation - Nortel CallPilot 201i Hardware Installation

November 2006

Completing the installation

Introduction
To complete the installation of the 201i server, lock the 201i into position.
The server starts up automatically.
ATTENTION
To complete the installation and start the 201i
server
Note: Ensure that the switch in which the 201i is installed is powered on.
1 Ensure that all peripheral devices are powered up (including the 201i
shelf).
2 Push the 201i server gently but firmly until it is flush with the backplane.
Result: The 201i server beeps for three seconds to indicate that power is
being received.
3 Close the lock latches to secure the 201i server to the backplane.
4 Ensure that the power status LED is lit.
5 Watch the HEX display on the 201i server.
The HEX display shows T:01 through T:08, and then HOST. This takes
about 13 seconds.
201i Server Hardware Installation
Connecting peripheral devices to the 201i server
When connecting the optional CLAN, do not power up
unless your antivirus programs and Nortel security updates
are installed first.
159