Nortel CallPilot 201i Hardware Installation page 139

November 2006
Starting the 201i server
When you lock the 201i into position against the switch backplane, the
server starts automatically. You can observe the startup process on both the
monitor and the 201i server faceplate.
ATTENTION
Before you begin
Before you connect the peripheral devices, ensure that you have completed
the following tasks:
1. Set the DIP switches on the external fax modem. See page 124.
2. Prepare the SCSI CD-ROM and tape drives. See the following:
"Setting the CD-ROM drive SCSI ID and DIP switches" on page 126
"Setting the tape drive SCSI ID" on page 128
"Setting SCSI device termination" on page 130
201i Server Hardware Installation
Connecting peripheral devices to the 201i server
Ensure that all peripheral devices are connected before you
lock the 201i server in position against the backplane.
The 201i server receives power and starts when the
connection with the backplane is established.
139