Nortel CallPilot 201i Hardware Installation page 89

November 2006
See the following diagram:
Note: After you remove the bracket, refasten the screws in their original locations
inside the cabinet.
3 Refasten the inner SCSI bracket screws in their original locations inside
the cabinet.
You will use the top screw later to fasten the NTRH3502 SCSI cable
drain wire.
4 Connect the low-profile right-angle SCSI connector on the NTRH3502
cable to the SCSI connector on the 201i server faceplate.
5 Fasten the SCSI cable drain wire to the top screw that previously held
the inner SCSI bracket in place.
201i Server Hardware Installation
Installing the 201i server in an Option 11C or Option 11C Mini
Inner SCSI
bracket
G101587
89