Nortel CallPilot 201i Hardware Installation page 105

Callpilot release 4.0
Hide thumbs Also See for Nortel CallPilot 201i:
Table of Contents

Advertisement

November 2006
a. Use a slot screwdriver to gently pry off the SUCCESSION label.
b. Insert the screwdriver approximately 2 cm (0.75 in.) into the open slot,
and then gently lift the screwdriver handle, thus applying downward
pressure on the tab inside the bezel.
At the same time, gently pull the bezel away from the chassis
(approximately 2 cm [0.75 in.]) until the inside tab has cleared the
catch.
c. Grasp the bezel by both sides and carefully pull it straight away from
the Media Gateway or Media Gateway Expansion.
201i Server Hardware Installation
Installing the 201i server in the Succession 1000 system
A
B
C
G101620
105

Advertisement

Table of Contents
loading

Table of Contents