Setting The Modem Dip Switches - Nortel CallPilot 201i Hardware Installation

Preparing peripheral devices

Setting the modem DIP switches

Introduction
Set the modem DIP switches to their default settings. This section describes
how to set the modem DIP switches if they have been changed from the
default settings.
To set the modem DIP switches
Ensure that the DIP switches are set as described in the following table. Use
a pair of tweezers or small screwdriver to set the DIP switches.
Note: The DIP switches are located on the back of the modem. ON is down.
OFF is up.
DIP Default
switch setting
1 OFF
2 OFF
3 ON
124
Function
Data Terminal Ready (DTR) override
OFF: Normal DTR operations (The computer must
provide a DTR signal for the modem to accept
commands. When DTR is dropped, the call is
terminated.)
ON: Modem ignores DTR (override)
Verbal/numeric result codes
OFF: Displays verbal (word) results
ON: Displays numeric results
Result code display
OFF: Suppresses result codes
ON: Enables result codes
Standard 1.07
CallPilot