Waste Toner Bottle Contact Block Removal - Lexmark X543 Service Manual

Waste toner bottle contact block removal

1. Open the front cover.
Remove the right cover assembly. See
2.
3. Remove the waste toner bottle. See
Remove the screw (A) from the back of the waste toner bottle contact block
4.
.
Remove the rear shield. See
5.
Disconnect the waste toner bottle contact block cable from connector JWT1 on the controller board.
6.
Remove the waste toner bottle contact block.
7.
"Right cover removal" on page
"Waste toner bottle" on page
"Rear shield removal" on page
4-7.
4-72.
4-7.
Repair information
7525-xxx
Previous
Next
Go Back
4-73