MOTO GUZZI Daytona RS Workshop Manual page 93

SERVICE SHAFT HOUSING
SERVICE SHAFT
SPRING SET CHECKING
NOTE: The Data in square brackets refer to the Model DAYTONA RS except for Models with
specifications for USA. SWITZERLAND and SINGAPORE - Fig. 11-75
When the valve seats on the heads have been milled it is necessary, after fitting the valves on the heads, to check
that the springs are compressed between 36.5 ÷37.5 mm [36 ÷ 36,5]; to obtain this value insert «A» washers of
appropriate thicknesses (these are supplied in thicknesses of 1 mm and 1.5 mm).
A
11-73
11-74
11-75
91