MOTO GUZZI Daytona RS Workshop Manual page 51

– Unscrew the con-rod screws from inside the crank-
case and remove the connecting rods (Fig. 10-34).
– Unscrew the 8 outer screws «A» holding the rear
flange «B» that supports the crankshaft (Fig. 10-35).
When reassembling, use some Teflon tape on the
2 screw marked with the arrow (Fig. 10-35) to
prevent oil from leaking through.
– Fit tool «C» (part no. 12 91 36 00) as shown in
Fig. 10-35A to remove rear flange «B».
Remove the flange and draw out the crankshaft
from the rear.
A
B
C
B
10-34
10-35
10-35A
49