MOTO GUZZI Daytona RS Workshop Manual page 119

How to interpret the codes of the CHECK LAMP:
ERROR CODE 1.1
The signal of the throttle potentiometer is incorrect.
The problem can be:
- That the potentiometer does not function correctly.
- Cabling harness/connection is damaged or is not correct.
ERROR CODE 1.2
Incorrect Signal from absolute pressure transducer
The problem can be:
- That the pressure transducer does not function correctly.
- Cabling harness/connection is damaged or is not correct.
ERROR CODE 1.4
Incorrect signal of oil temperature
The problem can be:
- That the temperature transducer (interrupted or in short circuit).
- Cabling harness/connection (interrupted or in short circuit).
ERROR CODE 1.5
Incorrect signal of air temperature
The problem can be:
- That the air temperature transducer (interrupted or in short circuit).
- Cabling harness/connection (interrupted or in short circuit).
ERROR CODE 1.6
Wrong Battery voltage
- A signal is sent when the output voltage of the battery is less than 8V or greater than 16 V.
ERROR CODE 2.3
Error on the injector 1
The problem can be:
- Cabling harness/connection damaged or not correct.
ERROR CODE 2.4
Fault on solenoid 1
The problem can be:
- Primary coil damaged.
- Cabling harness/connection damaged or not correct.
ERROR CODE 2.5
Fault on solenoid 2
The problem can be:
- Primary coil damaged.
- Cabling harness/connection damaged or not correct.
ERROR CODE 3.2
Error on the injector 2
The problem can be:
- Cabling harness/connection damaged or not correct.
ERROR CODE 3.3
Remote control switch of the fuel pump
The problem can be:
- Defective switch
- Cabling harness/connection damaged or not correct.
117