Download Print this page

Maintenance - Black & Decker HP96K Manual

Hide thumbs

Advertisement

Table of Contents
E N G L I S H
For screwdriving, set the collar to the desired
x
setting. If you do not yet know the appropriate
setting, proceed as follows:
Set the collar (3) to the lowest torque setting.
x
Tighten the first screw.
x
If the clutch ratchets before the desired
x
result is achieved, increase the collar setting
and continue tightening the screw.
Repeat until you reach the correct setting.
Use this setting for the remaining screws.
HP122K(D)/HP142K(D) - Drilling in masonry
(fig. H & I)
For drilling in masonry, set the collar (3) to the
x
hammer drilling position by aligning the
symbol
with the marking (21).
Slide the two-gear selector (5) towards the
x
front of the tool (2nd gear).
HP122K(D)/HP142K(D) - Two-gear selector (fig. I)
For drilling in steel and for screwdriving
x
applications, slide the two-gear selector (5)
towards the rear of the tool (1st gear).
For drilling in materials other than steel,
x
slide the two-gear selector (5) towards the
front of the tool (2nd gear).
Straight drilling indicator (fig. J)
This tool is fitted with an indicator to facilitate
straight drilling. This feature can be used both in
horizontal and in vertical position.
Position the tool as required.
x
Keep the switch (1) slightly depressed without
x
switching the tool on.
Slowly move the rear of the tool until the red
x
indicator (22) lights up.
Press the switch further to start drilling.
x
HP12KD/HP14KD/HP122KD/HP142KD -
Detecting pipes or wires (fig. K)
Take the detector (23) out of the holder (24).
x
Refer to the manual of the detector for further
x
instructions.
Drilling/screwdriving (fig. A)
Select forward or reverse rotation using the
x
forward/reverse slider (2).
To switch the tool on, press the switch (1).
x
12
The tool speed depends on how far you press
the switch.
To switch the tool off, release the switch.
x
Hints for optimum use
Drilling
Always apply a light pressure in a straight line
x
with the drill bit.
Just before the drill tip breaks through the
x
other side of the workpiece, decrease pressure
on the tool.
Use a block of wood to back up workpieces
x
that may splinter.
Use spade bits when drilling large diameter
x
holes in wood.
Use HSS drill bits when drilling in metal.
x
Use masonry bits when drilling in soft masonry.
x
Use a lubricant when drilling metals other than
x
cast iron and brass.
Make an indentation using a centre punch at
x
the centre of the hole to be drilled in order to
improve accuracy.
Screwdriving
Always use the correct type and size of
x
screwdriver bit.
If screws are difficult to tighten, try applying a
x
small amount of washing liquid or soap as a
lubricant.
Always hold the tool and screwdriver bit in a
x
straight line with the screw.

MAINTENANCE

Your Black & Decker tool has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
Your charger does not require any maintenance
apart from regular cleaning.
Before performing any maintenance on
x
the tool, remove the battery from the
tool.
Unplug the charger before cleaning it.
x

Advertisement

Table of Contents
loading

  Also See for Black & Decker HP96K

This manual is also suitable for:

Hp122k(d)Hp142k(d)Hp14k(d)Hp12k(d)