HP142K(D) Black & Decker declares that these tools INTENDED USE conform to: 98/37/EC, 89/336/EEC, Your Black & Decker drill/screwdriver HP96K/ 73/23/EEC, EN 50260, EN 55014, HP12K(D)/HP14K(D) has been designed for EN 60335, EN 61000 screwdriving applications and for drilling in wood, metal and plastics.
E N G L I S H Know your tool 9. Connect dust extraction equipment If devices are provided for the connection of Warning! When using battery-powered dust extraction and collection facilities, ensure tools, basic safety precautions, that these are connected and properly used. including the following, should always 10.
E N G L I S H 16. Store idle tools Neutralise with a mild acid such as lemon When not in use, tools, batteries and chargers juice or vinegar. In case of eye contact, should be stored in a dry, locked up or high rinse abundantly with clean water for at place, out of reach of children.
E N G L I S H HP96K/HP12K(D)/HP14K(D) 1. Two-speed on/off switch (HP96K) 2. Forward/reverse slider Never attempt to replace the charger unit 3. Mode selector / torque adjustment collar with a regular mains plug. 4. Chuck 5. Two-gear selector (HP122K(D)/HP142K(D)) HP122K(D)/HP142K(D) - Mains plug replacement 6.
Selecting the direction of rotation (fig. G) approx. 24 °C. For drilling and for tightening screws, use forward (clockwise) rotation. For loosening screws or HP96K/HP12K(D)/HP14K(D) (fig. D) removing a jammed drill bit, use reverse To charge the battery (9), remove it from the (counterclockwise) rotation.
E N G L I S H For screwdriving, set the collar to the desired The tool speed depends on how far you press setting. If you do not yet know the appropriate the switch. setting, proceed as follows: To switch the tool off, release the switch. Set the collar (3) to the lowest torque setting.
The product has sustained damage through Run the battery down completely, then remove foreign objects, substances or accidents; it from the tool. Technical data HP96K HP12K(D) HP14K(D) HP122K(D) HP142K(D) Voltage 14.4 14.4...
E N G L I S H Repairs have been attempted by persons other than authorised repair agents or Black & Decker service staff. To claim on the guarantee, you will need to submit proof of purchase to the seller or an authorised repair agent.
Australia WALT Industrial Power Tool Company Tel. 03 9895 9200 7 Clarice Road Fax 03 9899 7465 Box Hill, Victoria 3128 New Zealand Black & Decker Tel. 09 579 7600 81 Hugo Johnston Drive Fax 09 579 8200 Penrose, Auckland, New Zealand United Kingdom Black &...