Yamaha DM 2000 Owner's Manual page 92

78
Chapter 7—Input Channels
Selecting Surround Pan Modes
The Surround mode can be selected as follows.
1 Use the SELECTED CHANNEL PAN/SURROUND [DISPLAY] button to select
the Surround Mode page.
Use the cursor buttons to select the surround mode buttons, and press
2
[ENTER] to activate the selected mode.
The 3-1 Surround mode page is shown on the left; the 5.1 page on the right. The diagram
on each page shows the typical sound image placement and the Surround channel to Bus
Out configuration.
Using the Joystick
Use the LAYER buttons to select the Input Channel Layers, and use the [SEL]
1
buttons to select the Input Channels.
2 Press the [GRAB] button to grab the current Joystick position, and then use
the Joystick to set the surround pan.
The [GRAB] button, which is enabled only when a Surround mode other than Stereo is
selected, is used to turn on and off Joystick surround pan control for the currently selected
Input Channel. While Grab is on, the Joystick can be used to set the surround pan position
of the currently selected Input Channel. If the Joystick is set to control effects (i.e., the
[EFFECT] button indicator is lit), the [GRAB] button is disabled.
DM2000—Owner's Manual
PAN / SURROUND
L
DISPLAY
ODD
L R
R
EVEN
LINK GRAB EFFECT