Yamaha DM 2000 Owner's Manual page 31

B
EQ ON button
This button is used to turn the EQ of the currently selected channel on and off. Its indicator
lights up when the EQ is on. See "Using EQ" on page 107 for more information.
C
ATT control
This control is used to attenuate the pre-EQ signal of the currently selected channel. See
"Attenuating Signals" on page 106 for more information.
D
FREQUENCY/Q indicators
These indicators show whether each FREQUENCY/Q control is set to control frequency or
Q. The FREQUENCY indicator lights up when it's set to control frequency; the Q indicator,
when it's set to control Q. See "Using EQ" on page 107 for more information.
E
FREQUENCY/Q controls
These are rotary controls and push switches. The push switches are used to select either fre-
quency or Q. The current setting is shown by the FREQUENCY/Q indicators. The rotary
controls are used to set the frequency or Q, as selected by the push switches. See "Using EQ"
on page 107 for more information.
F
EQ GAIN controls
These controls are used to set the gain of each EQ band. See "Using EQ" on page 107 for
more information.
G
EQ displays
Normally these displays show the frequency of each band. When the GAIN is adjusted, the
gain value is displayed. When the Q is adjusted, the Q value is displayed. If the gain or Q is
not adjusted for two seconds, the frequency value reappears. See "Using EQ" on page 107
for more information.
CHANNEL COPY
A
COPY button
This button is used to copy channel settings to the Copy buffer. See "Copying Channel Set-
tings" on page 129 for more information.
B
PASTE button
This button is used to paste the settings in the Copy buffer to the specified channel. See
"Copying Channel Settings" on page 129 for more information.
Control Surface
CHANNEL
1
COPY
2
PASTE
17
DM2000—Owner's Manual