Selecting The Timecode Source & Frame Rate - Yamaha DM 2000 Owner's Manual

UPDATE: This button is the same as that on the Main and Memory pages. See "Automix
Main Page" on page 165 for more information.
EDIT OUT: The TAKEOVER and RETURN buttons are the same as those on the Main and
Memory pages. See "Automix Main Page" on page 165 for more information. The TIME
parameter determines the time it takes faders to return to levels specified by the existing
Automix data when the Edit Out mode is set to Return. It can be set from 0.0 to 30.0 seconds
in 0.1 second steps.
Selecting the Timecode Source & Frame Rate
The timecode source and frame rate for Automix can be set as follows.
Use the DISPLAY ACCESS [SETUP] button to select the Time Reference page.
1
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
TIME REFERENCE: The following timecode sources can be selected.
Source
INTERNAL
SMPTE
MIDI CLOCK
MTC
USB
SERIAL
SLOT1
MIDI
For the USB, SERIAL, and SLOT1 sources, you must specify a port from 1–8.
FRAMES: The frame rate can be set to: 30, 30D, 29.97, 29.97D, 25, or 24. An Automix will
playback correctly even if the frame rate is different to that which was used when the Auto-
mix was originally recorded.
The MIDI CLOCK source supports Song position Pointers, F8 TIMING CLOCK (timing
info), FA START (starts Automix from beginning), FB CONTINUE (starts Automix from
current position), and FC STOP (stops Automix).
Selecting the Timecode Source & Frame Rate
Description
Internally generated timecode
SMPTE timecode received via the SMPTE TIME CODE INPUT
MIDI Clock received via the MIDI IN port
MTC received via the MTC TIME CODE INPUT
MTC received via the USB TO HOST port
MTC received via the SERIAL TO HOST port
MTC received via Slot #1 (for use with an optional mLAN I/O Card installed in Slot #1)
MTC received via the MIDI IN port
171
DM2000—Owner's Manual