Yamaha DM 2000 Owner's Manual page 19

AD Input Section
AD Input #1 is shown here.
A
These switches turn on and off the +48 V phantom power feed to each INPUT A
+
48V
1
ON
(XLR-type connector). Phantom power is typically used to power condenser-type
OFF
microphones or direct boxes. See "Phantom Power" on page 48 for more information.
2
PAD
B
26dB
3
These switches turn on and off the 26 dB pad (attenuator) for each AD Input. See
- -
16 60 "Pad" on page 48 for more information.
4 GAIN
PEAK
5
C
SIGNAL
1
These controls adjust the gain of the AD Input Head Amps. They have an input sensi-
6
OFF
ON
INSERT
tivity of –16 dB to –60 dB or +10 dB to –34 dB when Pad is on. See "Gain" on page 48
for more information.
D
These indicators light up when the input signal level is 3 dB below clipping. See "PEAK
& SIGNAL Indicators" on page 48 for more information.
E
These indicators light up when the input signal level is 20 dB below nominal. See
"PEAK & SIGNAL Indicators" on page 48 for more information.
F
These switches are for turning on and off the AD Input inserts. See "AD Inserts" on
page 49 for more information.
Channel strips
Channel strip #1 is shown here.
The function of each channel strip depends on the currently selected Layer. See
1
"Selecting Layers" on page 42 for more information.
2
A
AUTO
3 These controls are used to edit Input and Output Channel parameters. Their exact
SEL operation depends on the currently selected Encoder mode and Layer. There are two
4
preset Encoder modes, Pan and Aux/Mtrx, and four assignable modes, with over 40
SOLO
parameters to choose from. See "Selecting Encoder Modes" on page 45 for more
5
information.
ON
1
The Encoders feature push switches that are used to punch the parameter currently
assigned to the Encoders in and out during Automix recording. See "Punching In &
Out Individual Parameters" on page 175 for more information.
C H 0 1
6
B
These buttons are used to set Automix recording and playback for each channel.
Their exact operation depends on the currently selected Layer. Their indicators light
up orange in Record-Ready mode, red while recording, and green during playback.
See "Channel Strip [AUTO] Buttons" on page 169 for more information.
C
10 0
These buttons are used to select Input and Output Channels for editing with the
5 5
0 10 SELECTED CHANNEL section. Their exact operation depends on the currently
5 15 selected Layer. The [SEL] button indicator of the currently selected channel lights up.
7
See "Selecting Channels" on page 43 for more information. They are also used to dis-
10 20
play the Long channel names. See "Channel Names" on page 41 for more informa-
30
15
tion. The [SEL] buttons can also be used to pair channels, and to add and remove
20 40
channels to and from the EQ, Comp, Fader, and Mute groups.
30 50
+48V ON/OFF switches
PAD switches
GAIN controls
PEAK indicators
SIGNAL indicators
INSERT ON/OFF switches
Encoders
AUTO buttons
SEL buttons
5
Control Surface
DM2000—Owner's Manual