Yamaha DM 2000 Owner's Manual page 105

To set Aux Send levels, select the rotary controls, and use the Parameter
5
wheel or INC/DEC buttons.
To set the Pre/Post parameters, select the PRE/POST buttons, and use the
6
[ENTER] button or INC/DEC buttons.
7 To set all Input Channels for the selected Aux Send to pre-fader or post-fader
simultaneously, select the GLOBAL PRE or POST button, and then press
[ENTER].
The PRE or POST button appears highlighted, and remains highlighted until the Pre/Post
setting of one or more channels is changed, so you can quickly see if all Input Channels are
set to either pre-fader or post-fader.
Fixed Mode
See page 88 for information on how to select Fixed Aux mode.
1 Use the AUX SELECT [DISPLAY] button to select the Aux Send pages.
The Input Channel 1–24 Aux Send page in Fixed mode is shown below. The layout of the
other three Aux Send pages in Fixed mode is the same.
2 Use the AUX SELECT [1–12] buttons to select Aux Sends 1–12.
Use the cursor buttons or Parameter wheel to select the Aux Send buttons.
3
Input Channels can also be selected by using the Input Channel Layer buttons and [SEL]
buttons.
4 Use the [ENTER] button or INC/DEC buttons to turn Aux Sends on and off.
If the Fader mode is set to Aux/Mtrx, the faders provide a visual indication of the On/Off
status of each Input Channel for the currently selected Aux Send. For Aux Sends that are on,
faders move to the nominal position. Aux Sends that are off, they move to the –∞ position.
On/Off settings cannot be changed by using the faders.
91
Aux Send Pages
DM2000—Owner's Manual