Yamaha DM 2000 Owner's Manual page 230

216
Chapter 19—Pro Tools Remote Layer
Trim Mode
Trim mode can be set as follows.
1 While holding down a channel's [AUTO] button, press the AUTOMIX [REL-
ATIVE] (TRIM) button.
The channel's Automation mode is displayed on the corresponding channel strip display
while its [AUTO] button is pressed.
Auto trim/write
Auto trim/touch
Auto trim/latch
Auto trim/read
Grouped channels are set together. You can temporarily disable a group in order to set indi-
vidual channels by pressing and holding the USER DEFINED KEYS [12] (CTRL/CLUTCH)
button.
The following shortcuts apply.
To do this...
Set Trim mode for all channels
Set Trim mode of all selected channels
In Trim mode, you can display channel and send level values relatively (instead of absolute
decibel values) on the channel strip displays by holding down the USER DEFINED KEYS
[13] (ALT/FINE) button while adjusting the faders and Encoders.
Arming Parameters for Automation
Parameters can be selected for automation recording as follows.
Use the following AUTOMIX-OVERWRITE buttons to arm parameters.
1
AUTOMIX-OVERWRITE Buttons
[FADER] (FADER)
[ON] (MUTE)
[PAN] (PAN)
[AUX] (SEND)
[AUX ON] (SEND MUTE)
[EQ] (PLUG-IN)
The button indicators for armed parameters light up.
The following shortcuts apply.
To do this...
Arm all parameters
Inverse armed parameter selection
DM2000—Owner's Manual
Pro Tools Channel Strip Displays
TWrt
Flashing red/orange (Record Ready)
TTch
Orange (Recording)
TLch
TRd Flashing green/orange
Do this!
USER DEFINED KEYS [5]+AUTOMIX [RELATIVE]
USER DEFINED KEYS [5]+USER DEFINED KEYS [4]+AUTO-
MIX [RELATIVE]
Pro Tools
Volume
Mute
Pan
Send level
Send mute
Plug-in
Do this!
USER DEFINED KEYS [5]+AUTOMIX-OVERWRITE [FADER],
[ON], [PAN], [AUX], [AUX ON], or [EQ]
USER DEFINED KEYS [13]+AUTOMIX-OVERWRITE [FADER],
[ON], [PAN], [AUX], [AUX ON], or [EQ]
[AUTO] Button Indicators